Verifying the configuration settings, To verify configuration settings, Run one of the following scripts – Sun Microsystems 6900 User Manual
Page 27: Sun proprietary/confidential: internal use only
Chapter 2
General Troubleshooting Procedures
7
Sun Proprietary/Confidential: Internal Use Only
Verifying the Configuration Settings
During the course of troubleshooting, you might need to verify configuration
settings on the various components in the Sun StorEdge 3900 or 6900 series.
▼
To Verify Configuration Settings
1. Run one of the following scripts:
■
Run the
runsecfg
(1M) script and select the various Verify menu selections for
the Sun StorEdge T3+ arrays, the Sun StorEdge network FC switch-8 and switch-
16 switches, and the virtualization engine components.
■
Run the
checkdefaultconfig
(1M) script to check all accessible components.
The output is shown in
■
Run the
checkswitch
(1M) |
checkt3config
(1M) |
checkve
(1M) |
checkvemap
(1M) scripts from
/opt/SUNWsecfg/bin
to check the settings on
the Sun StorEdge network FC switch-8 and switch-16 switches, the Sun StorEdge
T3+ array, and the virtualization engine.
The scripts check the default configuration files in the
/opt/SUNWsecfg/etc
directory and compare the current, live settings to those of the defaults. Any
differences are marked with a FAIL.
Note –
For cluster configurations and systems that are attached to Microsoft
Windows NT, the default configurations may not match the current installed
configuration. Be aware of this when running the verification scripts. Certain items
may be flagged as FAIL in these special circumstances.