Sanyo CH4242 - Manual (Page 25)

2 2 2 2 2
K
24 S4359146
3-12. Installing the Wall Fixture onto Wooden or
Gypsum Wall
Confirm that the wall is strong enough to support the unit.
a) If the Wall is Wooden
(1) Attach the wall fixture to the wall with the 9
screws provided. (Fig. 3-28)
If you are not able to line up the holes in the wall
fixture with the beam locations marked on the
wall, use rawl plugs or toggle bolts to go through
the holes on the panel or drill 13/64 in. dia. holes
in the panel over the stud locations and then
mount the wall fixture.
(2) Check with a tape measure or carpenter’s level.
This is important so that the unit is correctly
installed.
(3) Make sure the wall fixture is flush against the
wall. Any space between the wall and unit will
cause noise and vibration.
b) If the Wall is Brick, Concrete or Similar
Drill 3/16 in. dia. holes in the wall. Insert rawl plugs for
appropriate mounting screws. (Fig. 3-29)
Confirm that the wall is strong enough to support the unit.
a) If the Wall is Wooden
(1) Attach the wall fixture to the wall with the 12
screws provided. (Fig. 3-30) If you are not able to
line up the holes in the wall fixture with the beam
locations marked on the wall, use rawl plugs or
toggle bolts to go through the holes on the panel
or drill 3/16 in. dia. holes in the wall fixture over
the stud locations.
(2) Check with a tape measure or carpenter’s level
that the wall fixture is level. This is important so
that the unit is correctly installed.
(3) Make sure the wall fixture is flush against the
wall. Any space between the wall and unit will
cause noise and vibration.
b) If the Wall is Brick, Concrete or Similar
Drill 3/16 in. dia. holes in the wall. Insert rawl plugs for
appropriate mounting screws. (Fig. 3-29)
0943_T_I
Fig. 3-28
0944_T_I
3/16 in.
dia. hole
Rawl plug
Fig. 3-29
wall fixture
Wall fixture
1355_M_I
Fig. 3-30
KH2442
KH3642