Important – Sanyo CH4242 User Manual

Page 53

Advertising
background image

7

7

7

7

7

RC

(WL)

52

S4359146

7. HOW TO INSTALL THE WIRELESS REMOTE CONTROLLER

(OPTIONAL PART)

Important

When using this air conditioner (ECO multi system air

conditioner) with the wireless remote controller it may

sometimes be impossible to change the operation

modes while other indoor unit is running.

When this happens, a double beep tone sounds,

the (operation lamp) lights up, and the

(Timer

lamp) and

(Standby lamp) blink alternately.

Operation is the same even during (AUTO mode)

automatic cooling or heating.

A beep tone sounds 5 times and no changes can

be made when any of the ON/OFF, MODE, Tem-

perature setting buttons were pressed while set

under central control by the system controller.

7-1. Wireless Remote Controller Installation

The remote controller can be operated from either a

non-fixed position or a wall-mounted position.

To ensure that the air conditioner operates correctly,

do not install the remote controller in the following

places:

In direct sunlight.

Behind a curtain or other place where it is covered.

More than 26 ft. away from the air conditioner.

In the path of the air conditioner’s airstream.

Where it may become extremely hot or cold.

Where it may be subject to electrical or magnetic

interference.

(1)

If Wall-mounted Fixed Position

Install the remote controller at a convenient

location on a nearby wall. However, before

attaching the remote controller mounting cradle,

check that the remote controller can operate from

the desired wall position. (Fig. 7-1)

How to Install Batteries

See Fig. 7-2.

(1)

Press and slide the lid on the back of the remote

controller in the direction of the arrow.

(2)

Install two AAA alkaline batteries. Make sure the

batteries point in the direction marked in the

battery compartment.

(3)

Press the ACL button, then replace the lid. If you

press it, the current time, ON time, and OFF time

are all reset to 0:00.

Fig. 7-2

Fig. 7-1

1994_M_I

Mounting cradle

Put on

1

2

Push

Screws for fixture
Truss-head
tapping screws
(4

×

L5/8")

1995_M_I

ACL button

Cover

Advertising
This manual is related to the following products: