Seiko FB-900 - Manual (Page 127)

● Functions
Installing the Windows Printer Driver
The diskette provided with your printer contains the software you need to
operate your printer with Windows applications. Before you install the
printer driver, we recommend you to read the README.TXT file on the
diskette. The README.TXT file contains all the information necessary
to install the printer driver, as well as all other pertinent information
regarding this software.
The printer driver tells Windows what information to send to the printer,
including details about printer features, the printer interface, and fonts.
Follow the next procedure before installing the Windows printer driver.
1. Close all Windows applications. Otherwise you will get an error
message when you attempt to install the printer driver.
2. Set the following parameters of Memo 1-6 to the factory default setting
in the SETUP MODE.
#3 TOF ADJUSTMENT 14/60 inch
#6 TOP MARGIN 0 LINE
#7 BOTTOM MARGIN 0 LINE
#8 LEFT MARGIN 0 CHAR
#9 RIGHT MARGIN 0 CHAR
#10 QUALITY LQ
#12 CHARACTER PITCH 10 CPI
#13 LF PITCH 6 LPI
#14 ZOOM IN/OUT 100 %
Set the following parameters to the factory default setting in the
EXTENDED SETUP MODE.
#20 EMULATION EPSON
#27 CR SETTING CR ONLY
#28 LF SETTING LF + CR
#32 PAGE LENGTH LOCK NO
#33 FONT LOCK NO
#34 PITCH LOCK NO
#35 QUALITY LOCK NO
#36 CHARACTER TABLE LOCK NO
#44 SOFTWARE SETUP
VALID
IMPORTANT INFORMATION
1. COPYING RESTRICTIONS:
You may copy this software under certain restrictions. You may make
a backup copy or copy onto a hard disk. No more than two (2) copies
of this software are permitted to be in existence at any one time.
Every copy must include all notices and markings contained in the
original provided by SEIKO Precision Inc.
2. NO LIABILITY FOR CONSEQUENTIAL DAMAGES:
In no event shall SEIKO Precision Inc. be liable for any special,
indirect, incidental, or consequential damages in any way relating to
the use or rising out of the use of this software.
4-11 — 4. Functions —