Seiko FB-900 - Manual (Page 27)

1-4 —1. Setting up the printer—
●
Paper path
1
2
Paper loading direction
Rear tractor
(Optional)
Paper loading
direction
3
Paper rack
2. Front loading, top ejection
This paper path applies a smaller load to the paper.
This is recommended for printing on thick paper
(such as multipart paper or label sheets).
1. Front loading, rear ejection
This paper path is recommended if fanfold paper is
cut along the perforation frequently.
The perforation is automatically fed to the paper
cutter of the top cover by pressing the TEAR OFF
key so that the paper may be torn off easily.
To cut the paper, hold the upper cover firmly with
one hand and tear the paper towards you.
3. Rear loading, front ejection
Dual paper parking is available when the optional
rear tractor is used. Two types of fanfold paper of
different size and thickness may be used and
selected from the control panel or by issuing a
software command (ESC EM or software setup*)
from the computer.
* Software setup commands
The software setup commands are unique to this
printer. Most functions available on the SETUP
MODE and EXTENDED SETUP MODE can may
1 1 x 5 F . T R R E A R
1 1 x 5 F T R T O P
1 1 x 5 R . T R F R T N
Liquid crystal display
Inside of the printer viewed
from the right. ✩
Inside of the printer viewed
from the right. ✩
.
1
1
1
Path of fanfold paper
The three fanfold paper paths shown below are available. For selecting a paper
path, See pages 1-6 and 1-7.
Rear tractor (Option)
Front tractor