Seiko FB-900 - Manual (Page 215)

9-15 — 9. Software setup functions —
●
Command
Control code
Corresponding setup function
Code Hexadecimal
HD + I + 1 + 3 + n (1B,7C,60,04,00,49, (52) Protocol (SERIAL I/F) (Setup Function #75)
31,33,n)H
n = 0 DTR
1 X-ON/X-OFF 1
2 X-ON/X-OFF 2
3 ETX/ACK
This setting becomes valid after the setup command mode
is terminated.
HD + I + 1 + 4 + n (1B,7C,60,04,00,49, (53) Baud rate (SERIAL I/F) (Setup Function #76)
31,34,n)H
n = 0 38400 BPS
1 19200 BPS
2 9600 BPS
3 4800 BPS
4 2400 BPS
5 1200 BPS
6 600 BPS
7 300 BPS
This setting becomes valid after the setup command mode
is terminated.
HD + I + 1 + 5 + n (1B,7C,60,04,00,49, (54) Operation in case of serial error (SERIAL I/F)
31,35,n)H (Setup Function #77)
n = 0 Print " ❈ "
1 Ignored
This setting becomes valid after the setup command mode
is terminated.
HD + I + 1 + DC0 + n (1B,7C,60,04,00,49, (55) CTS signal (SERIAL I/F) (Setup Function #78)
31,10,n)H
n = 0 YES (ENABLE)
1 NO
This setting becomes valid after the setup command mode
is terminated.
See page 3-49.
See page 3-49.
See page 3-50.
See page 3-50.