Cr code function, Lf code function – Seiko FB-900 User Manual
Page 88
3-29
— 3. Setup options —
1. EPSON mode
If AUTOFEED is selected, the printer checks the AUTO
FEED signal during initialization. It executes a carriage
return with a line feed when the AUTO FEED signal is low.
It executes a carriage return with out a line feed when the
AUTO FEED signal is high. The AUTO FEED signal is
usable only when the PARALLEL interface or AUTO is
selected. A carriage return without a line feed is executed
when the SERIAL interface is selected.
2. IBM or HP mode
If AUTOFEED is selected, a carriage return without a line
feed is executed.
CR code function
Function
#
27
CR : CR ONLY
CR : CR + LF
27 CR SETTING
Carriage return without a line feed
CR : AUTOFEED
AUTO FEED signal enabled
Carriage return with a line feed
Supplementary notes
Setting procedures
This function specifies whether or not to feed a line
when the printer receives a carriage return (CR)
command.
LF code function
Function
#
28
LF : LF ONLY
LF : LF + CR
28 LF SETTING
Line feed without a carriage return
Line feed with a carriage return
Setting procedures
This function specifies whether or not to execute a
carriage return when the printer receives a line feed
(LF) command.
#
1~#
9
#10
~
#20
#20
~
#29
#30
~
#38
#40
~
#44
#50,
#51
#70
~
#79
#80
~
#84
#90
~
#95
#60
~
#67