Seiko FB-900 - Manual (Page 38)

1-15
7.
Open the tractor covers on both sides. Fit
the sprocket holes on both sides of the
fanfold paper to the tractor pins. Then close
the tractor covers. Push down the lock lever
of the right tractor.
8.
Close the front cover.
Hold both sides of the front cover with both
hands and pull down the front cover slowly.
Press the front cover to lock it.
—1. Setting up the printer—
●
Loading fanfold paper (Front tractor)
Fanfold paper setting procedures 4
By default, paper is
fed to the 14/60
inch (approximately
6 mm) position
from the top. This position
may be freely adjusted on
the SETUP MODE
between 0/60 inch (0 mm)
and 63/60 inches
(approximately 26.7 mm)
from the top of paper or the
perforation at a pitch of
1/60 inch.
The TOF position can be set from 0/60 inch (0
mm). However, if this position is set to 0/60 to
9/60 inch, paper may jam, depending on the paper condition. Normally,
it is recommended that the TOF position be adjusted to the 14/60 inch
(approximately 6 mm) position from the top of the paper.
Caution
when setting the paper on the tracter, Take care
not to over tighten or allow too much slack. Over
tightening deforms the guide holes and the paper may become
disconnected from the tracter during printing. Too much slack may
cause the paper to become clogged when it is inserted.
Caution