Sun Microsystems 5602 - Manual (Page 200)

A – Command Line Interface
Group Command
A-26 59097-01 A
0
Keywords add [group]
Initiates an editing session in which to specify a group member and its attributes
for the existing group given by [group]. ISL, Port, and MS member attributes are
described in
Table A-5 , Table A-6 , and Table A-7 respectively. The group name
and group type attributes are read-only fields common to all three tables.
Table A-5. ISL Group Member Attributes
Attribute Description
Member Worldwide name of the switch that would attach to the switch. A
member cannot belong to more than one group.
Authentication Enables (CHAP) or disables (None) authentication using the
Challenge Handshake Authentication Protocol (CHAP). The default
is None.
Primary Hash The preferred hash function to use to decipher the encrypted
Primary Secret sent by the ISL member. The hash functions are
MD5 or SHA-1. If the ISL member does not support the Primary
Hash, the switch will use the Secondary Hash.
Primary Secret Hexadecimal string that is encrypted by the Primary Hash for
authentication with the ISL group member. The string has the
following lengths depending on the Primary Hash function:
„ MD5 hash: 16-byte
„ SHA-1 hash: 20-byte
Secondary Hash Hash function to use to decipher the encrypted Secondary Secret
sent by the ISL group member. Hash values are MD5 or SHA-1. The
Secondary Hash is used when the Primary Hash is not available on
the ISL group member. The Primary Hash and the Secondary Hash
cannot be the same.
Secondary
Secret Hex string that is encrypted by the Secondary Hash and sent for
authentication. The string has the following lengths depending on
the Secondary Hash function:
„ MD5 hash: 16-byte
„ SHA-1 hash: 20-byte
Binding Domain ID of the switch to which to bind the ISL group member
worldwide name. This option is available only if
FabricBindingEnabled is set to True using the Set Config Security
command. Refer to the
”Set Config Command” on page A-61 .
0 (zero) specifies no binding.