Sun Microsystems 5602 - Manual (Page 236)

A – Command Line Interface
Set Config Command
A-62 59097-01 A
0
PortType Port type:
„ 1-Gbps/2-Gbps Ports: GL, G, F, FL, Donor. The default
is GL.
„ 10-Gbps Ports: G
SymbolicPortName Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is Port n where n is the port number.
ALFairness
(1-Gbps/2-Gbps ports
only) Arbitration loop fairness. Enables (True) or disables (False)
the switch’s priority to arbitrate on the loop. The default is
False.
DeviceScanEnabled Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information during
login. The default is True.
ForceOfflineRSCN Enables (False) or disables (True) the immediate
transmission of RSCN messages when communication
between a port and a device is interrupted. If enabled, the
RSCN message is delayed for 200 ms for locally attached
devices and 400 ms for devices connected through other
switches. The default is False. This parameter is ignored if
IOStreamGuard is enabled.
ARB_FF
(1-Gbps/2-Gbps ports
only) Send ARB_FF (True) instead of IDLEs (False) on the loop.
The default is False.
InteropCredit Interoperability credit. The number of buffer-to-buffer credits
per port. 0 means the default (16) is unchanged. Changing
interoperability credits is necessary only for E_Ports that are
connected to non-FC-SW-2-compliant switches. Contact your
authorized maintenance provider for assistance in using this
feature.
ExtCredit
(1-Gbps/2-Gbps ports
only) Extended credits. The number of port buffer credits that this
port can acquire from donor ports. The default is 0.
FANEnable
(1-Gbps/2-Gbps ports
only) Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address, port
name, and node name to the logged-in NL_Port. The default
is True.
Table A-18. Set Config Port Parameters (Continued)
Parameter Description