Sun Microsystems 5602 - Manual (Page 240)

A – Command Line Interface
Set Config Command
A-66 59097-01 A
0
InteropMode Propagates just the active zone set throughout the
fabric (Standard, FC-SW-2 compliant) or the entire
zoning database (Interop-1, non-compliant). The
default is Standard.
LegacyAddressFormat Available only when the InteropMode parameter is
Interop-1, this parameter enables (True) or disables
(False) the use of legacy address formatting for
interoperating with non-FC-SW-2 switches. The
default is False.
Table A-20. Set Config Switch Parameters (Continued)
Parameter Description