Sun Microsystems 5602 - Manual (Page 268)

A – Command Line Interface
Show Command
A-94 59097-01 A
0
port [port_number]
Displays operational information for the port given by [port_number]. Ports are
numbered beginning with 0. If [port number] is omitted, information is displayed for
all ports.
Table A-27 describes the port parameters.
Table A-27. Show Port Parameters
Entry Description
AIinit Incremented each time the port begins AL initialization.
AIinitError Number of times the port entered initialization and the
initialization failed.
Bad Frames Number of frames that have framing errors.
ClassXFramesIn Number of class x frames received by this port.
ClassXFramesOut Number of class x frames sent by this port.
ClassXWordsIn Number of class x words received by this port.
ClassXWordsOut Number of class x words sent by this port.
ClassXToss Number of times an SOFi3 or SOFn3 frame is tossed from
TBUF.
DecodeError Number of decode errors detected
EpConnects Number of times an E_Port connected through ISL negotiation.
FBusy Number of times the switch sent a F_BSY because Class 2
frame could not be delivered within ED_TOV time. Number of
class 2 and class 3 fabric busy (F_BSY) frames generated by
this port in response to incoming frames. This usually indicates
a busy condition on the fabric or N_Port that is preventing
delivery of this frame.
Flowerrors Received a frame when there were no available credits.
FReject Number of frames from devices that were rejected.
InvalidCRC Invalid CRC detected.
InvalidDestAddr Invalid destination address detected.
LIP_AL_PD_ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets,
performed.
LIP_F7_AL_PS This LIP is used to reinitialize the loop. An L_Port, identified by
AL_PS, may have noticed a performance degradation and is
trying to restore the loop.