Sun Microsystems 5602 - Manual (Page 260)

A – Command Line Interface
Set Setup Command
A-86 59097-01 A
0
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table A-26 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
trap community password can be up to 32 characters excluding
#, semicolon (;), and comma (,). The default is “public”.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled Enables (True) or disables (False) SNMP communication with
other switches in the fabric. The default is True.
Note: Changing the IP address will terminate all Ethernet management
sessions.
Table A-26. System Configuration Settings
Entry Description
Eth0NetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Eth0NetworkAddress Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Eth0NetworkMask Ethernet subnet mask address.
Eth0GatewayAddress Ethernet IP address gateway.
AdminTimeout Amount of time in minutes the switch waits before
terminating an idle Admin session. Zero (0) disables the
time out threshold. The default is 30, the maximum is
1440.
InactivityTimeout Amount of time in minutes the switch waits before
terminating an idle Telnet command line interface
session. Zero (0) disables the time out threshold. The
default is 0, the maximum is 1440.
Table A-25. SNMP Configuration Settings (Continued)
Entry Description