Liebert Universal Monitor - Manual (Page 18)

Installation - Main Board
10
2.0 I
NSTALLATION
- M
AIN
B
OARD
This section provides instructions for installing, mounting and connecting power to the Universal
Monitor. For information on the optional Expansion Board, see 3.0 - Installation - Optional Expan-
sion Board.
2.1 Installation Considerations
The Universal Monitor must be installed indoors and may be mounted on the surface of a wall or
flush-mounted, depending on the user’s application, the location of equipment and sensors to be mon-
itored and the type of wall the unit will be mounted on.
The Universal Monitor should be mounted where it can be easily accessed. On-site personnel would
access the unit through the LCD on its front cover, service terminal connected to the RS232 port or
through SiteScan. For off-site monitoring, the Universal Monitor should be placed near communica-
tions means such as a telephone line connection that would permit remote access.
In addition to the communications connections, the site also must have electrical service and must
permit connecting the unit’s eight digital inputs, eight digital outputs and four analog inputs.
The wall material must be capable of supporting the weight of the Universal Monitor: see 10.0 -
Specifications.
2.1.1 Unpacking and Preliminary Inspection
• Before unpacking the Universal Monitor, inspect the shipping carton for damage or signs of
mishandling, such as gashes or holes in the carton or severely flattened corners.
• Open the shipping crates carefully. Use care to avoid puncturing the container with sharp objects
that might damage the contents.
• Inspect the Universal Monitor and all included components for damage.
• If any damage from shipping or mishandling is observed, immediately file a damage claim with
the shipping agency and forward a copy to:
Liebert Corporation
1050 Dearborn Drive
P.O. Box 29186
Columbus, OH 43229
Packing Contents
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Table 5 Packing manifest - Universal Monitor main board
Standard Components
• Universal Monitor - large or small enclosure
• User Manual
• Keys (2) to panel door lock
• Backup Battery - installed in unit (not connected or charged)
• RS232 Configuration Cable