Liebert Universal Monitor - Manual (Page 96)

Connecting to the Service Terminal Interface
88
A.2.3 Set Up the COM1 Port - Direct Connection Only
The following steps apply only to setting up a direct connection to the Service Terminal Interface via
the Universal Monitor’s RS232 port. If you are setting up a remote connection via modem, skip to
Step 8 (next section).
COM1 Port Setup
6. In the COM1 Properties window, shown below, make the following selections:
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
7. Click OK. When the connection is open, the connection name appears in the title bar of the
HyperTerminal window. To complete the setup, continue with Step 8 (next section).