Lincoln Electric COMMANDER SVM145-B - Manual (Page 104)

TROUBLESHOOTING & REPAIR
F-48 F-48
COMMANDER 300 Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
CONTROL TRANSFORMER TEST (continued)
FIGURE F.20 – FRONT CONTROL PANEL REMOVAL
FRONT
CONTROL
PANEL
SCREWS
SCREW
TEST PROCEDURE
1. This test should be performed with the
engine off.
2. Using the 3/8" wrench, remove the four
screws holding the front control panel to the
case top and sides. See Figure F.20. (There
are two screws on the top and one on each
side.)
3. Carefully lower the front control panel.