Lincoln Electric COMMANDER SVM145-B - Manual (Page 142)

TROUBLESHOOTING & REPAIR
F-86 F-86
COMMANDER 300 Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
POWER MODULE/OUTPUT RECTIFIER BRIDGE ASSEMBLY
REMOVAL AND REPLACEMENT (continued)
FIGURE F.39 – CONTROL PANEL REMOVAL
FRONT
CONTROL
PANEL
SCREWS
SCREW
TEST PROCEDURE
1. Turn the engine off.
2. Using the 3/8" wrench, remove the screws
holding the front control panel to the case top
and sides. See Figure F.39. (There are two
screws on the top and one screw on each
side.)
3. Carefully lower the front control panel.
4. Using the 3/8" wrench, remove the front left
and right side panels.
5. Perform the Output Panel Removal
Procedure.
6. Perform the Power Module Capacitor
Discharge Procedure.
7. Optional: With the 7/16" wrench, remove the
ground wire from the output panel assembly.
If the ground wire is not in the way, it can
remain attached.