Troubleshooting & repair, Warning stator/rotor removal and replacement – Lincoln Electric COMMANDER SVM145-B User Manual
Page 151
TROUBLESHOOTING & REPAIR
F-95
F-95
COMMANDER 300
WARNING
STATOR/ROTOR REMOVAL AND REPLACEMENT
Service and repair should be performed by only Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician
or machine operator and will invalidate your factory warranty. For your safety and to avoid
electrical shock, please observe all safety notes and precautions detailed throughout this
manual.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical trou-
bleshooting assistance before you proceed. Call 1-800-833-9353 (WELD).
TEST DESCRIPTION
The following procedure will aid the technician in removing and replacing the Commander
300 stator and rotor.
MATERIALS NEEDED
3/8" Wrench
Slot head screw driver
7/16" Wrench
Phillips head screw driver
1/2" Wrench
Gear puller (small)
3/4" Wrench
Hoist
1" Open end wrench
Feeler gauge (for air gap check)
1-1/8" Wrench
This procedure should take approximately 5
1
⁄
2
hours to perform.