Roland VC-1 D-50 - Manual (Page 14)

14
Try Out the Sounds
1. In the upper right of the screen, touch < > . A pulldown menu appears.
2. In the pulldown menu, touch <INFO> . The Information window appears.
fig.08-13
3. This window shows the following information.
Ver.: The VC-1’s program version
4. When you have finished viewing the information, press [EXIT] to close the window.
You can specify whether or not a beep tone will be heard when you touch a valid point on the touch
screen. At the factory setting, the beep tone will be sounded.
fig.03-07
1. In the upper right of the screen, touch < > . A pulldown menu
appears.
2. In the pulldown menu, touch <Beep> to add a check mark ( ✔ ).
With this setting, the beep tone will be heard. If you perform the
same procedure once again, the check mark will be cleared and the
beep tone will no longer be heard.
Viewing Various Information
Enabling or Disabling the Beep Tone
vc1_for_XT_e1 14 ページ ２００５年３月８日 火曜日 午後１２時５５分