Roland VC-1 D-50 - Manual (Page 37)

37
Overview of the VC-1
fig.07-01(MemorySuructure)
Work Area
Once the V-Synth XT has started up the VC-1, the system program and patch data is loaded from the
VC-1 into the V-Synth XT. The section where the system and patch data is loaded is called the
Work Area .
Content loaded to the Work Area is cleared when the V-Synth XT’s power is turned off.
In addition, banks (containing data for 64 patches) bulk dumped from an original D-50 (or other MIDI
device) are also stored temporarily in the Work Area. Bulk dumped data is cleared if the power is simply
turned off, so be sure to save the data to the VC-1 (p. 27).
Temporary Area
Patch data selected for performance is further taken from the Work Area and placed in memory called the
Temporary Area . Editing of tones and factors is performed on patches in this Temporary Area. Edited
patch data is lost if the power is simply turned off, so be sure to save these to the VC-1 (p. 27).
Memory Structure
Wave
(128)
Patch:Int1
(64)
Int1–Int8 (512)
Work Area
Patch
(1)
Temporary Area
Patch
Select
Patch
Write
Wave
(128)
Patch:Int1
(64)
Int1–Int8 (512)
Wave
(100)
Patch
(64)
Bulk Load
Bulk Dump Power ON
Patch Write
Bank Save
1
2
1
2
vc1_for_XT_e1 37 ページ ２００５年３月８日 火曜日 午後１２時５５分