Roland VC-1 D-50 - Manual (Page 68)

68
Tone Parameters
T4 (Time 4
Sets the time needed to reach point 4 from point 3.
Value: 0–100
T5 (Time 5)
Sets the time needed to reach point 5 from the moment the key is released.
Value: 0–100
TVA ENV Level
fig.09-44(LCD_TvaEnvLevel)
L1 (Level 1)
Sets the level of point 1.
Value: 0–100
L2 (Level 2)
Sets the level of point 2.
Value: 0–100
L3 (Level 3)
Sets the level of point 3.
Value: 0–100
SusL (Sustain Level)
Sets the level of point 4.
Value: 0–100
EndL (End Level)
To lower the level after releasing the key, set this to 0, and to raise the level, set it to 100.
Value: 0, 100
* The End Level remains until the key is released and played again. That is, at a value of 100, the sound remains.
However, the PMC Sound Generator’s One-shot sounds do not remain even when set to 100.
* If the levels of two adjacent points are set to similar values, the time between these two points may prove to be
shorter than what is actually set, or even zero.
vc1_for_XT_e1 68 ページ ２００５年３月８日 火曜日 午後１２時５５分