Midi – Roland VC-1 D-50 User Manual
Page 73
73
Settings for the Entire VC-1
fig.10-04(LCD_SystemMidi)
MIDI
MIDI CH (MIDI Channel)
Sets the
Basic Channel
(MIDI channel on which the VC-1
receives and transmits messages).
Value:
1 – 16
*
The transmit change can be set to a different number from the Basic
Channel individually from each Patch (p. 25).
Control
Determines how to receive messages from an external MIDI
device. (
Value:
B.CH, G.CH, MdeOFF
SeparateCH (Receive Channel in Separate Mode)
When
SEP
(Separate Mode) or
SEP-S
(Separate Solo Mode) is selected, the Upper and Lower Tones can
be controlled on different channels. The Lower Tone is controlled by the basic channel, and the Upper
Tone is controlled by the receive channel set here. The MIDI keyboard can control only the Upper Tone.
Value:
1 – 16
*
Prog.C (Program Change Switch)
To receive or transmit Program Change messages, set this to
On
.
Program Change messages are transmitted only when a Patch is selected by operating the V-Synth XT’s
panel buttons, or when the Program Change number to be transmitted is altered also on the V-Synth XT’s
panel. IN other words, Program Change messages are not transmitted by patch selection with the
Program Change messages sent from an external MIDI device.
Value:
Off, On
*
Display
Function
B.CH
(Basic Channel mode)
When the VC-1 is being controlled in Mono mode, it receives the Voice
massages (except for Note Event, Pitch Bender) on the Basic Channel
from the external device.
G.CH
(Global Channel mode)
When the VC-1 is being controlled in Mono mode, by an external device
that has a Global Channel (one number smaller than the basic channel)
it can receive all the Voice massages (except for Note Event, Pitch
Bender) On the Global Channel.
MdeOFF
(Mode Message OFF mode)
In this mode, the VC-1 does NOT receive the Mode massages from the
external MIDI device, but is assigned to the Key mode as set on the
VC-1.
vc1_for_XT_e1 73 ページ ２００５年３月８日 火曜日 午後１２時５５分