Roland VC-1 D-50 - Manual (Page 33)

33
Transferring Patches To and From the D-50/550
Using the D-50
1. Use a MIDI cable to connect the V-Synth XT’s MIDI OUT connector to the D-50’s MIDI IN connector.
2. Set the D-50 and V-Synth XT to the same MIDI channel (the basic channel; p. 73).
3. Turn the Memory Protect of the D-50 to OFF .
3-1. Press the [TUNE/FUNCTION] button.
3-2. Select “ Protect ” with the Selector button and turn it OFF with the joystick.
4. Enable reception of bulk load data on the D-50.
4-1. Press the D-50’s [DATA TRANSFER] button.
4-2. While pressing the D-50’s [DATA TRANSFER] button, specify (B.Load) with the Selector
button .
4-3. Press the D-50’s ENTER] button.
fig.04-05a
5. Turn the Exclusive Sw of the V-Synth XT to On .
5-1. Press [MODE] .
5-2. Touch <SYSTEM> .
5-3. Select “ Exclusive Sw ,” then turn the V-Synth XT’s VALUE
dial to specify On .
6. Press [MODE] on the V-Synth XT. The MODE MENU window
appears.
7. Touch <DATA TRANSFER> . The DATA TRANSFER screen
appears.
fig.04-06(LCD_DataTrans_BulkDump)
8. Touch <B.Dump> in the left of the screen. The MIDI Bulk Dump
screen appears.
9. Modify the value by either turning the VALUE dial or pressing
[INC/+] or [DEC/-] .
Source Bank
Selects the Patch Bank in the VC-1 with the patch data to transfer
to the D-50.
Value: I1 – I8, P1 – P6
10. Touch <OK> . The bulk dump starts. If you want to cancel without
executing, touch <Cancel> .
11. When the data transfer is completed, the D-50’s display shows “ Complete .”
12. Press the [EXIT] button on the D-50 to return to the play mode.
Transferring Patches from the VC-1 to the D-50/550
12 3-1 4-3 4-1, 4-2 3-2
vc1_for_XT_e1 33 ページ ２００５年３月８日 火曜日 午後１２時５５分