Roland ATELIER AT-500 - Manual (Page 171)

169
Recording/Playing Back What You Play
Recording/Playing Back What You Play
The performance data that you recorded will disappear when
the power of the ATELIER is turned off. If you wish to keep the
performance data, you can save it on a USB memory, floppy
disk, or “Favorites” (user memory).
If the recorded performance data has not been saved, the
display will show the “ ” symbol. This symbol will
disappear when you save the performance data.
1. Prepare to save the performance song.
If you want to save performance song to a USB memory,
connect the USB memory to the External Memory
connector.
If you want to save performance song to a floppy disk,
connect the floppy disk drive to the Ext Drive connector.
Into the floppy disk drive, insert a floppy disk that was
formatted by the ATELIER.
2. Touch <Rec/Play> on the Main screen.
The Rec/Play screen appears.
fig.07-04-2.eps
3. Touch < > (Utility).
The Utility screen appears.
fig.07-22-2.eps
4. Touch <Save/Delete>.
The Song Save/Song Delete screen appears.
fig.07-28-2.eps
5. Touch < > < > to select the save-
destination media.
Select “Ext Memory” to save the data in USB memory,
select “Disk” to save it on a floppy disk, or “Favorites” to
save it in user memory.
6. Touch < > < > to select the number of the
save destination.
If the save destination contains no data, the screen will
indicate
“ - - - - -.”
fig.07-28-2.eps
To cancel the Save operation, touch <Exit> to close the
Song Save/Song Delete screen.
7. Touch <Save>.
The Save Format screen appears.
fig.07-29.eps
Saving Performance Songs
AT-500_e.book 169 ページ ２００８年７月２８日 月曜日 午後４時１７分