Tunturi T90 Rehab - Manual (Page 3)

GB
O W N E R ’ S M A N U A L
•
T 9 0
3
exercise equipment and what makes for efficient
training at Tunturi’s website at WWW.TUNTURI.cOM .
ASSEMBLY
Before assembling the device, insure all parts are
present:
pAcKAGE 1/3
1. Running base
2. Power cord
pAcKAGE 2/3
3. Handrails
4. Handlebar/meter unit
5. Assembly kit (contents are marked with an * in the
spare part list): keep the assembly tools, as you may
need them e.g. for adjusting the equipment
pAcKAGE 3/3
6. Extended handrails (Assembly: page 100)
The directions left, right, front and back are defined
as seen from the exercising position. In case of
problems contact your Tunturi dealer. The package
includes a silicate bag for absorbing moisture during
storage and transportation. Two people are needed
for the installation. Assemble the equipment as
follows:
Open both packages and remove all protective
styrox foam pieces.
HANDRAILS
Secure the handrail mounting pieces to the lower
ends of the handrails, using six hex screws (A)
on each mounting piece. Tighten these screws
carefully. NOTE! The left handrail and mounting
piece are marked with a round red sticker. Secure
both handrails to the running base with two hex
screws (B) and washers (c) and with one hex screw
(D) and a washer (E) . Be careful not to damage the
wire coming out of the left handrail. NOTE! Do not
tighten these bolts until the handlebar and meter
have been secured.
HANDLEBAR AND METER
Turn the sliders located at the sides of the
handlebars downward so that you can attach them
with another screw (F) through the lower hole of
the handlebar. NOTE! Attach the screws as loosely as
possible. Do not remove the screws on the sliders.
Place the handlebar/meter unit on the handrails so
that the sliders fit the handrail grooves. Connect
the wire coming out of the left handlebar with the
connector in the meter and push the connected
wire inside the handlebar. Push the handlebar/
meter unit onto the handrail ends and tighten all
the hex screws on the sliders.
Be careful not to damage the handgrip pulse wire:
make sure that the wire runs along the middle
groove in the handrail. Fasten the handrail bolts.
Remove the protective film from the display.
Connect the wire coming out of the left handlebar
with the connector located under the running
base on the left hand side. For easier access, tilt the
treadmill slightly on its right side.
SAFETY KEY
The treadmill cannot be used if the key is not
properly installed on the meter; if the key
is removed from its place, the treadmill will
immediately stop. Insert the safety key into the key
holder at the left side of the meter. Ensure that the
clip of the safety key is properly attached to your
clothing; as the cord tightens, make sure the clip
does not detach itself from your clothing before the
safety key disconnects from the user interface.