Tyco 4100U - Manual (Page 101)

6-1
The SPS is described in Chapter 2. A picture is shown in Figure 2.4.
This chapter has the current and voltage ratings of the system power supply (SPS) and
describes how it is installed and configured by the factory. It also describes the Alarm
Relay Card that mounts onto the SPS to provide 3 extra relays.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
SPS Specifications 6-2
SPS Configuration 6-4
SPS LED Indications 6-5
Troubleshooting on SPS 6-6
The Alarm Relay Card 6-7
Chapter 6
The System Power Supply & Alarm Relay Card
Introduction
In this Chapter