Installing the idnet card onto the pdi, Overview, Installing the idnet card onto the pdi -4 – Tyco 4100U User Manual
Page 126: Overview -4, Figure 8-2, Mounting onto the power distribution interface -4
Advertising
8-4
The 4100-series IDNet card is designed to be mounted on the PDI in a 4100U expansion
cabinet. The card can be mounted on any of the PDI connectors.
Use connector P2, labeled on the back side of the IDNet card, to connect to any of the
eight PDI connectors as shown in the figure below.
Figure 8-2. Mounting onto the Power Distribution Interface
Installing the IDNet Card onto the PDI
Overview
IDNet CARD
STANDOFFS
#6 SCREWS
WASHERS
PDI CONNECTOR
(reverse side)
PDI
SCREW
RETAINERS
Advertising