Operator interface, Additional cpu bay modules, Expansion bays – Tyco 4100U User Manual
Page 34: Operator interface -6, Additional cpu bay modules -6, Expansion bays -6, Figure 2-3, Introduction to facps (4100u)
2-6
The operator interface lets a user operate the panel. It provides alarm, trouble, and isolate
status alerts, and lets the user review historical logs and perform diagnostics.
Figure 2-3. Operator Interface
The CPU bay can be equipped with many additional types of modules. The cards listed
below are limited to the CPU bay only.
4100-6030 Service Modem Card. CPU mezzanine card. Provides a connection to remote
PCs for diagnostics and programming purposes. (Not approved for use in Australia).
4100-6014 Modular Network Interface Card (NIC). A daughter card that mounts to the
CPU motherboard. Performs 4100 networking operations. May be installed with the
4100-6056 Wired Media Card and/or the 4100-6057 Fiber Media Card.
An FACP always has the CPU in the first bay, but it may have further expansion bays.
Expansion bays contain a variety of additional modules that the system might require.
Continued on next page
Introduction to FACPs (4100U),
Continued
Operator Interface
Additional CPU
Bay Modules
Expansion Bays