Wiring with the wired media card, Wiring with the wired media card -15, Figure 5-10 – Tyco 4100U User Manual
Page 95: Coupler wiring -15, Step 4. wiring network cards
5-15
The illustration below shows coupler wiring.
Figure 5-10. Coupler Wiring
Refer to the guidelines and figures in this topic to use wired media cards.
IMPORTANT: TB1 on the wired media card must not be used when it is
connected to the 4100-6014 NIC.
• When the 565-413 Interface Card is used with 565-516, -407, or –409 Network
Card, TB1 on the 565-413 Interface Card cannot be used. Connection to the
motherboard is required as shown.
• The shield should only be connected at one end of the line. The shield is
connected to the left port.
• When wiring leaves the building, 2081-9044 Overvoltage Protectors are
required. One overvoltage protector is installed where wiring leaves the building;
another is installed where wiring enters the next building.
Continued on next page
Step 4. Wiring Network Cards,
Continued
4190-9010 Coupler
Requirements
(continued)
Wiring with the
Wired Media Card