TechniSat DigiCorder S2 - Manual (Page 103)

Output digital:
SP/DIF output
electrical, Cinch socket
optical, Toslink
Dolby Digital AC3
Video parameters:
Output:
Output level FBAS
1 Vs-s +/- 0.3 dB to 75 Ohms
Output level Y 1 Vs-s +/- 0.3 dB to 75 Ohms
Output level C 1 Vs-s +/- 0.3 dB to 75 Ohms
Output level RED 0,7 Vs-s +/- 0.1Vp-p to 75 Ohms
Output level GREEN 0,7 Vs-s +/- 0.1Vp-p to 75 Ohms
Output level BLUE 0,7 Vs-s +/- 0.1Vp-p to 75 Ohms
S/N weighted > 60 dB
Videotext
Teletext filtering
corresp. to ETS 300 472 standard
Scanning Teletext data (FBAS) corresp. to ITU-R BT.653-
2 lines: 6-22 and 320-335
Soft videotext 1000 pages memory
TV SCART:
Output:
RGB, FBAS or S-Video
VCR SCART:
Input:
RGB, FBAS or S-Video
Output: FBAS
S-VHS Hosiden socket:
Output
Y signal (luminence),
C signal (chrominence)
Hard drive:
Hard drive type
3,5 inch
Hard drive controller intended for 80 to 250 GB
No. of recordings 999 (max.)
max. duration of recording
per recording
26 hours
Display:
Vacuum fluorescence
16-digit, 5x7 point matrix, 7 mm
character height
Serial interface RS 232:
Type
RS 232, bidirectional
Bit rate 115,2 kBit/s max.
Connector D-SUB socket, 9 pin
Function Update for operating software and
preprogramming
USB interface:
Type
USB 2.0 and USB 1.1 compatible
Bit rate up to 480 Mbit/s (2.0) / up to 12
Mbit/s (1.1)
Connector 1 USB host connector
Function Update for operating software and
preprogramming; USB stick; exter-
nal hard drive;
103
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 103