TechniSat DigiCorder S2 - Manual (Page 29)

> Use the arrow keys up/down to select, e.g. the
programme list type Total list and confirm by pres-
sing OK.
The alphabetically sorted Total list, containing all pro-
grammes, will be displayed. (Fig. 7-3)
> Use the arrow keys up/down to mark the pro-
gramme you wish to view.
> Additional information on the current programme can
be obtained by pressing the yellow function key
INFO.
> Confirm by pressing OK.
or
> Press the green function key PVR to go direct to the
hard drive navigator.
7.2.4 Calling up blocked programmes
If a programme is selected that is blocked by the parental
control function, the message Unit PIN will be displayed on
screen. (Fig. 7-4)
> Use the numeric keys to enter your PIN code.
The desired programme can now be viewed.
or
> Switch to a programme that is not blocked.
If you have selected the setting Once under Point 9.3.1, the
system will call for the PIN code once when a blocked pro-
gramme is selected. Thus, in order to make operation more
comfortable for you, you need to enter the PIN code only
once during each viewing session.
7.2.5 Infobox
Each time you change programmes, an information box (Fig.
7-5) will be displayed briefly, showing the programme slot
and the programme name of the programme selected. In
addition, other programme properties will be indicated, such
as
for Videotext, for a 16:9 format broadcast,
for encrypted programmes, for Dolby Digital broadcasts,
for sub-titles, for Mono broadcasts. In addition a yel-
low bar will be displayed indicating the amount of time of that
programme that has already elapsed. Also, where available
from the provider, the SFI genre as well as the age restric-
tions, if any, will be shown.
29
(Fig. 7-3)
(Fig. 7-4)
(Fig. 7-5)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 29