TechniSat DigiCorder S2 - Manual (Page 79)

9.3 Parental control
Your receiver is equipped with a parental control function.
This means that important functions (e.g. calling up the main
menu) can be protected from unauthorised use. In addition,
recordings and channels that you have blocked can only be
accessed by entering a four-digit PIN code (unit PIN). To
adjust settings in the menu Parental control proceed as
follows:
> Press the Menu key to call up the Main menu.
> Use the arrow keys up/down to mark the line
Settings.
> Confirm by pressing OK.
The sub-menu Settings will be displayed.
> Use the arrow keys up/down to mark the line
Parental control.
> Confirm by pressing OK.
The menu Parental control will be displayed. (Fig.
9-11)
> Use the arrow keys up/down to move the market
within the menu and to change the individual positions
as indicated.
When selecting a menu item, please also note any
messages displayed on screen.
9.3.1 PIN query mode
> In this line, use the arrow keys left/right to set
the pin query mode of the parental control function to
Once or Never.
If you set the pin query mode to Once, and have not yet
changed the PIN, you will be requested to change the PIN.
To do this, proceed as described in Point 9.3.2.
Never
If you select the setting Never you will never be asked for
the PIN. The parental control function is switched off.
Once
If you select the setting Once you will be asked to enter the
PIN when calling up the main menu or when selecting a blok-
ked channel resp. a blocked hard drive recording. To make
matters more convenient for you, you will be asked for the
PIN only once in each operating cycle.
79
(Fig. 9-11)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 79