TechniSat DigiCorder S2 - Manual (Page 96)

10.3.2.1 Test transponder/LNB configuration
To change the data of the test transponder in question, pro-
ceed as follows:
> Use the arrow keys to mark the field Current
satellite list.
> Press the OK key to open the satellite list.
> Use the arrow keys up/down to mark the satellite
position for which you wish to change the data.
> Confirm by pressing OK.
> Now use the arrow keys to mark the field LNB
Config. and press the OK key.
The menu LNB settings will be displayed.
(Fig. 10-12)
> In this menu, enter the data of the test transponder as
well as of the LNB used as described in Point 6.4.3.
> Press the Back key to return to the settings for the
motorised antenna.
10.3.2.2 Positioning antenna manually
You can determine the optimum position for the desired
satellite by monitoring the indicators for signal strength and
signal quality. Adjust the dish so that both bar graphs show a
maximum value.
> Use the arrow keys up/down to mark the field
save.
> Now use the arrow keys right (to mark the field
East) resp. left (to mark the field West) to rotate the
dish to the desired position. In each case keep the key
pressed down until the position has been reached.
10.3.2.3 Automatic fine adjustment (Autofocus)
Before saving a satellite position, you should perform the
automatic focussing function. In this, the dish is calibrated for
optimum reception.
> Press the blue function key Actions to open the
window listing the available actions.
> Now use the arrow keys up/down to mark the line
Autofocus.
> Confirm by pressing OK.
> Press the yellow key (Autofocus) to start the auto-
focus procedure.
The message Autofocus will be displayed while the
automatic adjustment procedure is in progress.
(Fig. 10-13)
96
(Fig. 10-12)
(Fig. 10-13)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 96