TechniSat DigiCorder S2 - Manual (Page 31)

> Confirm by pressing OK.
Your digital receiver will now show the option selected.
7.3.2 Selecting a starting time
On some channels you have the option of selecting various
starting times for viewing specific movies. These movies can
thus be viewed around the clock, at specific starting times.
Where a channel provides the facility of selecting starting
times, this will be indicated (Fig. 7-8) angezeigt.
> To select one of the available starting times, press the
Option key.
A selection window will be displayed, showing the
available starting times. (Fig. 7-9)
> Use the arrow keys up/down to select the desired
starting time.
> Confirm by pressing OK.
If the programme is validated for the starting time you
have set, you can proceed to view this at the desired
time.
7.3.3 Simultaneous reception of two encrypted pro-
grammes
Your receiver is able to receive two different encrypted pro-
grammes simultaneously, using only a single CI module and
a single valid Smartcard. However, this is only possible when
using a “Dual-Decrypt” compatible CI module (see specifica-
tions given by manufacturer of CI module), and then only if
both desired programmes are located on the same transpon-
der.
Please also note the item CI Dual decoding in the Special
functions Point 6.5.3.
7.4 Volume control
You have the facility to adjust the volume of your digital
receiver. This facilitates the easy operation of the receiver, as
it means you have all the important functions on a single
remote control, and will only rarely have to resort to using the
remote control of the television set. When you switch on the
digital receiver, sound will be reproduced at the volume level
last set.
> To adjust the volume of your digital receiver, press
Volume + to increase the volume, and Volum - to
decrease it.
> To switch the sound off (mute), press the key Sound
on/off press the key again to switch the sound on gain.
Please note:
The volume of the digital audio outputs cannot be adjusted.
31
(Fig. 7-8)
(Fig. 7-9)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 31