TechniSat DigiCorder S2 - Manual (Page 86)

9.5 Service settings
You can at any time access the factory default settings. Also,
you can, if the programme list has become obsolete through
changes made by the programme providers, delete the pro-
gramme list completely and perform a new programme scan.
Please note that after performing the delete function you must
first start a programme scan, and must then transfer the des-
ired programmes from the Total list to the Favourites list.
> Use the Menu key to call up the Main menu. (Fig.
9-22)
> Now use the arrow keys up/down to mark the
menu line Settings.
> Confirm by pressing OK.
The sub-menu Settings will be displayed (Fig. 9-23)
> Now use the arrow keys up/down to mark the line
Service settings.
> Confirm by pressing OK.
The sub-menu Service settings will be displayed.
(Fig. 9-24)
9.5.1 Activate factory default setting
f this function is called up, the factory default setting will be
implemented, personal settings will be deleted, and the instal-
lation assistant AutoInstall will be started. Any data on the
hard drive (recordings, MP3s, etc.) will be retained.
> Use the arrow keys up/down to mark the line
Activate default setting.
> Press the OK key.
The query message will be displayed: “Do you really
want to activate the default setting?”.
> Use the arrow keys left/right to select Yes or
No.
> Confirm the entry by pressing OK.
9.5.2 Delete all programmes
This function will delete all programme memory banks.
> Use the arrow keys up/down to mark the line
Delete all programmes.
> Press the OK key.
The query message will be displayed: “Do you really
want to delete all programmes?”.
> Use the arrow keys left/right to select Yes or
No.
> Confirm the entry by pressing OK.
86
(Fig. 9-23)
(Fig. 9-22)
(Fig. 9-24)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 86