TechniSat DigiCorder S2 - Manual (Page 97)

10.3.3 Saving a satellite position
When you have completed the autofocus procedure, you
must still save the satellite position in memory.
> To do this, use the arrow keys to mark the field
save.
> Press the OK key.
Now, the set test transponder is used to check
whether a signal is being received at this position. It
will also determine whether the position to be saved is
a position that is already included in the pre-pro-
gramming. (Fig. 10-14)
If this is the case, the following message will be dis-
played: Orbital position xx determined. Save
satellite ? (Fig. 10-15)
> To save the satellite position, use the arrow keys
left/right to mark the field Yes, and confirm by
pressing OK.
If during this checking of the test transponder no pre-
programmed position is recognised, or if the signal is
too weak, appropriate messages will be displayed on
screen. (Figs. 10-16 and 10-17)
> To save the satellite position, use the arrow keys
left/right to mark the field Yes and confirm by
pressing OK.
10.4 Current satellite list
The saved satellite positions can be found in the satellite list.
Positions that have not yet been saved are indicated in this
list marked with an “*”.
> To rotate the dish to a position included in the satellite
list, use the arrow keys to mark the field Current
satellite list.
> Press the OK key.
> Use the arrow keys up/down to select the desired
position.
> Confirm by pressing OK.
The dish will now be rotated to theposition selected.
The ongoing rotation will be indicated in the menu by
the blinking message “turn”.
97
(Fig. 10-14)
(Fig. 10-15)
(Fig. 10-16)
(Fig. 10-17)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 97