TechniSat DigiCorder S2 - Manual (Page 17)

> Press the green function key Update. (Fig. 5-5).
The new software for your receiver will now be down-
loaded.
This procedure may take a few minutes.
> If you do not wish to download the new software at
this time, press the yellow function key Skip.
> If now new software is available at the present time,
press the green function key Continue.
You will then proceed to the programme search func-
tion.
Programme/channel search/ISIPRO
You have verious options of searching for new channels,
resp. of updating the programme list.
You can either use the ISIPRO programme list function to
download a new programme list for your receiver from the
satellite, or you can perform a programme scan/search.
> To download a current programme list, use the arrow
keys up/down to mark the line ISIPRO program-
me list update.
(Fig. 5-6)
> Confirm by pressing the green function key Start.
The current programme list will now be downloaded
from the satellite. Please note any messages display-
ed on screen, as well as the explanations under Point
9.5.3.
If you wish to perform a programme scan, proceed as fol-
lows:
> Use the arrow keys up/down to mark the field All
programmes if you wish to search for both free-to-
air and encrypted programmes, or All unencrypted
if you wish to search only for free-to-air programmes.
> Start the scanning procedure by pressing the green
function key, and an automatic programme scan will
be performed. All the satellites included in your anten-
na configuration will be scanned for programmes. This
procedure may take a few minutes. Please note any
messages displayed on screen.
17
(Fig. 5-5)
(Fig. 5-6)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 17