TechniSat DigiCorder S2 - Manual (Page 98)

10.4.1 Turning to a satellite position
To turn the antenna to the position set in the satellite list, your
digital receiver is equipped with the function turn to sat.
> To open the window listing the available actions, press
the blue function key Actions.
> Now use ther arrow keys up/down to mark the line
turn to sat.
> Confirm by pressing OK.
> Press the yellow function key turn to sat to turn
the antenna to the satellite position selected.
10.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as
follows:
> Use the arrow keys to mark the field Current
satellite list.
> To open the current satellite list, press the OK key.
> Use the arrow keys up/down to select the satellite
you wish to delete.
> Confirm by pressing OK.
> Use the arrow keys to mark the field Delete
satellite.
> To delete the satellite selected, press the OK key.
> Mark the field OK and confirm by pressing OK.
10.6 Reference position
When installing the external installation, the motor must be
set to the reference position (0°). You can therefore use the
function “Go to reference position” to turn the motor to this
position (0°) at any time.
> Press the green function key Ref.pos. to turn the
antenna automatically to the reference position.
98
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 98