TechniSat DigiCorder S2 - Manual (Page 16)

Country setting
> Use the arrow keys to select the country in which
you are located.
The selection made here will result in the time zone
being set, and will affect the sorting of the programme
list. (Fig. 5-2)
> Confirm by pressing the green function key Accept
to accept the selection, and to go to the selection of
antenna signals.
Antenna signals
Here you must select how many antenna signals are connec-
ted to the receiver.
> Use the arrow keys left/right to select whether5
you have connected one or two antenna signals.
(Fig.5-3).
> Use the green function key Accept to confirm and
accept the selection, and to go to the antenna configu-
ration.
Antenna configuration
This step of the installation allows you to adjust the setting of
your digital receiver to the configuration of your antenna.
> If you wish to accept the standard antenna configura-
tion, press the green function key Accept. (Fig. 5-4)
In this case proceed with the point “Software upda-
te”.
> If the configuration of your reception installation does
not conform to the standard setting, press the yellow
function key Change.
> Now proceed to make the antenna settings for your
installation, as described in more detail under Point
6.4.
> Press the red function key Back to return to the
overview of the antenna configuration.
> Use the green function key Accept to confirm and
accept the settings, and to go to the software update.
Software updating
When you have completed making the antenna settings, the
digital receiver will check whether any new version of the soft-
ware for the receiver is available via satellite. If a new version
is available, you can perform an automatic software update.
16
(Fig. 5-3)
(Fig. 5-4)
(Fig. 5-2)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 16