TechniSat DigiCorder S2 - Manual (Page 112)

For daily use
Switching on and off
> Switch the digital receiver on by pressing the
On/Stand-by key either on the receiver or on the
remote control.
> Press this key again to switch the receiver off again.
> The receiver is now in stand-by mode, the current time
will be shown in the display.
Programme selection
Using the programme up/down keys
> Use the Programme keys up/down either on the
receiver or on the remote control to move up or down
by one position in the programme list.
Using the numeric keys
> Use the numeric keys to enter the desired pro-
gramme number. For example
1 for programme slot 1
1, then 4 for programme slot 14
2, then 3, then 4 for programme slot 234
1, then 5, then 6 then 7 for programme slot 1567
When entering programme numbers consisting of several
digits, you have approx. 3 seconds time after pressing a key
to complete the entry.
If you wish to enter a number consisting of only one, two or
three digits, hold down the key for the last digit a little longer
to speed up the switching procedure.
Using the programme list
> Press the OK key.
> You can now mark the desired programme using the
arrow keys up/down.
> Press the OK key to switch to the programme selec-
ted.
> Use the arrow keys up/down to move the marker
around the list one line at a time.
> Use the arrow keys left/right to move through the
list one page at a time.
Volume control
> Adjust the volume of your digital receiver by using the
keys Volume + to increase the volume resp.
Volume - to decrease the volume.
> Press the Sound on/off key to switch the sound on
or off (mute).
112
080206 2233520000100
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 112