TechniSat DigiCorder S2 - Manual (Page 90)

Independently of whether you have switched the automatic
updating function on or off, the receiver will check each time
you switch it on whether a new version of the operating soft-
ware for your digital receiver is available. If a new version of
the operating software is available, this will be indicated by a
message displayed on screen (Fig. 9-33).
To start an update of the software, simply follow the instruc-
tions on screen.
When the update of the software has been successfully com-
pleted, an appropriate message will be displayed on screen.
> Press the green function key Continue to return to
normal operation.
9.5.5 Copying settings
You have the facility to copy all the settings such as program-
me list, antenna settings, etc. of your digital receiver (source,
transmitter) to another digital receiver (target, receiver) of the
same type, and equipped with the same version of operating
software.
> To do this, connect the two receivers by means of a
null modem cable.
> Switch on the target receiver.
> Use the arrow keys up/down to mark the line
Copy settings and confirm by pressing OK. A mes-
sage will be displayed (Fig. 9-34).
> To copy the settings, press any key on the panel of the
source receiver.
The settings of the source receiver will now be trans-
ferred to the target receiver. Please note any messa-
ges displayed on screen.
9.6 System configuration
This menu item allows you to see the specific receiver unit
data (e.g. the current software version).
>
Use the arrow keys up/down to mark this line in
the sub-menu Settings.
> Confirm by pressing OK.
> Press the Menu key to return to normal operation.
9.7 Encryption system
Under this menu item you can go to the sub-menues of any CI
modules inserted. By confirming with OK, you can see infor-
mation on the CI module used resp. on the Smartcard inserted.
Manual initialisation of the CI module
> You can manually initialise the CI module by pressing
the green function key CI Reset.
90
(Fig. 9-34)
(Fig. 9-33)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 90