TechniSat DigiCorder S2 - Manual (Page 106)

106
Problem Possible cause Solution
Time not displayed in stand-by
mode Time not acquired Set to major channel, e.g. ZDF for
approx 30 secs.
Receiver cannot be operated Receiver blocked > Press on/standby key on recei-
ver or remote control for approx. 5
secs.
Receiver cannot be switched on or
operated Receiver blocked Perform flash resert. Note! All perso-
nal settings will be lost.
>
Disconnect mains power.
> Simultaneously press standby
and programme up key on
receiver and keep them pres-
sed down.
> While standby and programme
up key are depressed, recon-
nect mains power.
> Keep keys pressed down
approx. 5 secs. until display *
“FLAS” appears.
USB device not recognised USB device formated in incorrect file
system Format USB device in file system
FAT32
No hard drive recordings possible Hard drive is full Delete existing recording(s)
Deleting hard drive recordings not
possible File system of hard drive damaged Check hard drive (Point 8.3.5)
Second encrypted programme can-
not be viewed. The two programmes selected are
not located on the same transponder Select two programmes located on
the same transponder
CI dual decoding not switched on Switch on CI dual decoding
(see Point 6.5.3)
The CI module used is not compati-
ble with “Dual Decrypt” Use a CI module with “Dual Decrypt”
capability
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:38 Uhr Seite 106