TechniSat DigiCorder S2 - Manual (Page 61)

8.3.1.2 Parental control
You can block access to recordings that are not suitable for
children or adolescents. These recordings can then only be
played and viewed after the four-digit unit PIN code has been
entered. The parental control function is only active if it has
been switched on as described in Point 9.3.
> Press the green function key to block access to the
marked recording. The recording selected will be indi-
cated as blocked by the parental control symbol.
8.3.1.3 Edit
> Press the yellow function key Edit to go to the
menu that will alow you to edit the marked hard drive
recording (Fig. 8-11). This will be displayed in a pre-
view window (1). In addition, the markers set in this
recording (2) will be indicated.
The markers Start and End are set as a standard fea-
ture. In addition, a yellow progress bar (3) will be
displayed, showing the current playback position and
the total duration of the recording.
> To skip to a marked spot of the recording, use the
arrow keys up/down to mark the desired marker,
and confirm by pressing OK.
Going to any spot of the recording
> Use the coloured keys to go directly to various
spots of your choice in the recording.
Functions
> Press the green function key Menu to open a win-
dow (Fig. 8-12) showing the functions available for
editing the recordings.
> Use the arrow keys up/down to select the desired
function, and confirm by pressing OK.
Setting a marker
> Go as described above to the spot in your recording
at which you would like to insert a marker.
> Press the green function key Menu to open a win-
dow showing the functions available.
> Use the arrow keys up/down to mark the line Set
marker.
> Press the OK to set a marker at this spot of the recor-
ding.
Proceed in this manner to set markers at all desired spots of
the recording.
61
(Fig. 8-11)
1
2
3
(Fig. 8-12)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 61