Perform utility setup, Midi settings – Pioneer SVM-1000 User Manual
Page 36
PERFORM UTILITY SETUP
36
En
PERFORM UTILITY SETUP
MIDI SETTINGS
MIDI is an acronym for “Musical Instrument Digital Interface” and
refers to a protocol developed for the exchange of data between
electronic instruments and computers.
A MIDI cable is used to connect components equipped with MIDI
connectors to enable the transmission of data.
The SVM-1000 will use the MIDI function to send operational
information for hardware and BPM (timing clock).
SYNCHRONIZING AUDIO SIGNALS TO
EXTERNAL SEQUENCER, OR USING
SVM-1000 INFORMATION TO OPERATE
AN EXTERNAL SEQUENCER
1
Use a commercially available MIDI cable to connect the
SVM-1000’s MIDI OUT connector to the MIDI sequencer’s
MIDI IN connector.
• Use to connect the USB MIDI output connector of the SVM-
1000 to a USB port on your computer. Supported operating
systems include Windows Vista, Windows XP or Mac OSX.
• For details regarding computer setup, refer to the
instruction manual for your computer and operating system.
For application setup instructions, refer to the instruction
manual for the application involved.
• Set the MIDI sequencer’s synch mode to “Slave”.
• MIDI sequencers that do not support MIDI timing clock
cannot be synchronized.
• Synch may not be achieved if the track’s BPM cannot be
detected and measured stably.
• BPM values set with the TAP mode can also be used to
output the timing clock.
2
Set the MIDI OUT to ON in the MIDI setup.
• The output range of the MIDI timing clock is 40 BPM to 250
BPM.
Note:
The BPM may not be measured correctly with some tracks.
Synchronize the computer application to the audio
signals, or operate the computer application using
the operation data for the SVM-1000.
1
Connect the USB MIDI output connector of the SVM-1000 to
your computer using the USB cable.
• Perform the MIDI settings for the application program. For
further information, refer to the instruction manual for
application program.
• Supported operating systems include Windows XP and Mac
OSX.
Set up MIDI
1
Hold the UTILITY (SET UP) button depressed.
The MIDI setup mode will be initiated.
2
Touch [MIDI].
The MIDI setup screen will be displayed.
3
Touch each applicable button.
Touch each applicable button on the screen to operate the
MIDI setup.
4
Touch [EXIT].
This will end the MIDI setup mode.
HI
10
9
8
7
6
5
4
3
2
1
0
10
9
8
7
6
5
4
3
2
1
0
UTILITY
(SET UP)
MIDI OUT
Switches the MIDI signal ON/OFF.
TIMING CLOCK
SYNC.
Switches the MIDI timing clock
synchronization between start and stop.
SNAP SHOT
Current MIDI information regarding dials
and buttons is transmitted.
BUTTON TYPE
Select the method in which the MIDI
signal is transmitted. Options include
toggle type and trigger type. In the trigger
type, any MIDI codes set to OFF will not be
sent, and MIDI codes set to ON will be
sent each time the button is pressed.
MIDI CHANNEL
Changes the MIDI channel. Configures
MIDI channels (1-16) and stores them in
memory.
01_SVM-1000_En.book 36 ページ ２００７年１０月１６日 火曜日 午前９時２２分