Pioneer SVM-1000 - Manual (Page 46)

TROUBLESHOOTING
46
En
Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and then
on again.
No video image, or image is
disrupted. • VIDEO INPUT switch is set incorrectly.
• Connection cables are not connected properly,
or are disconnected.
• Connectors or plugs are dirty.
• Trim controls are set improperly.
• Signal format of the input video source does not
match the system setting selected during
hardware setup.
• The TV monitor’s video signal format does not
match the system setting selected during
hardware setup.
• The TV monitor’s input selector is not set to the
input type actually connected to the unit.
• The TV monitor’s component setting is set to
something besides 525i (interlaced).
• Set the VIDEO INPUT switch to select the
currently playing component.
• Connect correctly.
• Clean away any dirt before connecting.
• Adjust trim properly.
• Select the hardware setup’s system settings to
match the format of the video signal for the
input/output video components.
• Set the TV monitor’s input selector to the type of
input connected to this unit.
• Set the TV monitor’s component setting to 525i
interlaced).
The character pressed on the
keyboard is not entered. • The keyboard connected to the USB connector
does not match the setting selected during this
unit’s keyboard language setup.
• Set the keyboard language setup to match the
type of keyboard connected to the USB
connector.
No response when touch panel
is touched. • Touch panel’s calibration is incorrect. • Set calibration properly in hardware setup’s
touch panel setting.
Symptom Possible Cause Remedy
01_SVM-1000_En.book 46 ページ ２００７年１０月１６日 火曜日 午前９時２２分