Uad-1 track advance, Overview, When to use trackadv – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 106
UAD Powered Plug-Ins Manual
- 106 -
Chapter 9: UAD Delay Compensation
UAD-1 Track Advance
Overview
The previous discussions on delay compensation (see
) apply mainly when using only audio tracks. When
MIDI tracks are played simultaneously alongside audio tracks, a different (but
related) synchronization issue can arise.
Let’s say you have a MIDI track and an audio track with a UAD-1 plug-in on
the audio track insert. In this scenario, the host application will automatically
compensate for latency and no use of the UAD DelayComp or UAD Track Ad-
vance is required.
However, if the audio track is sent to a send/group/bus and that
send/group/bus has a UAD-1 plug-in on it, the audio track will be delayed
in relation to the MIDI track because the host does not compensate for latency
automatically on groups/buses (unless full-path latency compensation is im-
plemented in the host). If the MIDI track was an audio track, you would use the
UAD DelayComp on it to compensate for the latency. But you can’t put a UAD
DelayComp on a MIDI track, so what to do?
Enter the UAD-1 Track Advance plug-in (TrackAdv for short). It operates just
like the DelayComp plug-in, but backwards. Instead of delaying unprocessed
tracks, it shifts them forward. It does this by reporting to the host application
that a track has a UAD plug-in on it, so the host compensates for the latency.
However, the track audio is not actually processed by the UAD so the net re-
sult is that the audio plays early.
Note:
UAD TrackAdv is available for UAD-1 only.
Note:
The Track Advance plug-in only works in hosts that support partial
(track inserts only) automatic delay compensation.
When to use
TrackAdv
UAD TrackAdv should be used whenever MIDI tracks are played alongside
audio tracks that are assigned to a send/group/bus that is using UAD-1 plug-
in(s).
Figure 24. The UAD Track Advance plug-in window