Cabinet on/off button, Output level meter, Phasor module – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 404: Sync button, Rate knob, Sweep knobs
UAD Powered Plug-Ins Manual
- 404 -
Chapter 38: Nigel
Cabinet On/Off
Button
Enables or disables the Cabinet module within Preflex. The Cabinet is en-
gaged when the button indicator is bright red. You can use this switch to com-
pare the Cabinet settings to that of the original signal or bypass the entire
Cabinet section to reduce UAD DSP load.
Output Level
Meter
This LED-style VU meter displays the level of the signal at the output of the Cab-
inet. Just before the red ‘LED’ is illuminated, the signal is at 0 dB. In order to
avoid overloading your host application signal path, adjust the Preflex output
level so that the signal is at or below 0 dB.
Phasor Module
The Phasor is a frequency-variable comb-filter with low frequency oscillator
modulation. It is capable of producing dramatic sweeping and swooshing ef-
fects, including modern and classic sounds such as those produced by the
Mutron Bi-Phase, Small Stone and MXR series of phasors.
Sync Button
This button puts the plug-in into Tempo Sync mode. See
for more information.
Rate Knob
Sets the LFO modulation (sweep) rate of the Phasor. The available range is
from 0.03 Hz to 10 Hz.
Sweep Knobs
The Sweep knobs determine the frequency range that will be affected by the
Phasor. The low and high frequency values can be independently adjusted.
This flexible arrangement allows the Phasor to affect a narrow or broad fre-
quency range, and also enables you to tune the frequency response charac-
teristic to match the signal if desired.
Figure 133. The Phasor plug-in window