L/c meter – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual

Page 386

Advertising
background image

UAD Powered Plug-Ins Manual

- 386 -

Chapter 37: Neve 88RS Channel Strip

Slower release times can smooth the transition that occurs when the signal
dips below the threshold, which is especially useful for material with frequent
peaks. However, if the release is too long, compression for sections of audio
with loud signals may extend to sections of audio with lower signals.

Note:

Fast release times are typically only suitable for certain types of percus-

sion and other instruments with very fast decays. Using fast settings on other
sources may produce undesirable results.

L/C Meter

This meter displays the amount of gain attenuation occurring in
the limiter/compressor module.

EQ

The UAD Neve 88RS “Formant Spectrum EQ” (AMS-Neve's descriptor) is di-
vided into four frequency bands (see

Figure 127 on page 387

): High Fre-

quency (HF), High Midrange Frequency (HMF), Low Midrange Frequency
(LMF), and Low Frequency (LF). The high and low bands can be switched into
shelving and/or High-Q modes. The two midrange bands are fully paramet-
ric. The EQ module can be disabled altogether.

When the high frequency (HF) and/or low frequency (LF) band is in shelf
mode, the band gain affects the band frequency. As gain is increased, the
shelf frequency more closely matches the knob value. As gain is reduced how-
ever, the low shelving frequency moves higher, and the high shelving fre-
quency moves lower.

With the UAD Neve 88RS EQ, the Q value and range is dependent on the
gain setting of the band. With any non-zero gain setting, the Q will be calcu-
lated in real-time for that band. But if the band gain is zero, Q will always dis-
play zero.

“The unique sound of AMS-Neve EQ is the result of years of research and ex-
tensive studio experience.”

Advertising
This manual is related to the following products: