Dual mode, Parameter copy buttons – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 442
UAD Powered Plug-Ins Manual
- 442 -
Chapter 43: Precision Equalizer
Dual Mode
In Dual mode (dual-mono mode), the left and right parameters can be inde-
pendently adjusted so that each side of the stereo signal can have different
EQ settings. Note that this mode is infrequently used during mastering be-
cause phase, imaging, and level inconsistencies may be induced in the result-
ing stereo signal.
Mode Selection
Any of the below methods may be used to modify the Mode value:
• Click the Stereo button to cycle through modes A and B
• Click the Dual button to activate dual-mono mode
• Click the indicator light above each mode
• Click+hold+drag the indicator light above each mode.
Parameter Copy
Buttons
The Parameter Copy buttons provide an easy method for copy-
ing parameter values. The behavior of the buttons is determined
by the current operating mode of Precision Equalizer.
Note:
The values that existed at the destination before copying are lost.
Stereo Mode
When in Stereo mode (see
), clicking A > B cop-
ies the left AND right parameter values from parameter set A to parameter set
B, and clicking the A < B button copies all the values from parameter set B to
parameter set A.
This feature is useful when you want to make an EQ change to a stereo signal
while maintaining the original values so the two settings can be easily com-
pared.
Note:
The high-pass filter parameter is global per preset and is not affected by
this control.
Parameter Copy in Dual Mode
When in Dual mode, the A and B buttons behave as left and right channel
copy buttons. Clicking A > B copies all the values from the left channel pa-
rameters to the right channel parameters, and clicking A < B copies all the val-
ues from the right channel parameters to the left channel parameters.