Tape speed, Tape type, Set up the plug-in by first adjusting – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 155
UAD Powered Plug-Ins Manual
- 155 -
Chapter 12: Ampex ATR-102
OFF is similar to the
position in the
that the Meters are still active when the Thru control is used. However, in this
state, the Meters indicate signal levels at the input of the plug-in prior to pro-
cessing.
Note:
DSP usage is reduced only when DSP LoadLock (
If DSP LoadLock is enabled (the default setting), activating OFF will not reduce
DSP usage.
Tape Speed
The Tape Speed control determines the speed of the tape trans-
port, in inches per second (IPS). Tape Speed affects the re-
corder’s fidelity and associated “head bump” sonics. Head
bump is bass frequency build-up that occurs with magnetic tape;
the dominant frequencies shift according to transport speed.
To change the Tape Speed value, click the IPS text values, or drag the knob,
or click the knob then use the mouse scroll wheel.
15 IPS is considered the favorite for rock and acoustic music due to its low fre-
quency “head bump” (low frequency rise) and warmer sound, while 30 IPS is
the norm for classical and jazz due to its lower noise floor, greater fidelity and
flatter response. 7.5 and 3.75 IPS are also available for an even more col-
ored experience, with even greater frequency shift and other artifacts.
Note:
The available parameter ranges of Tape Type, Head Width, and Em-
phasis EQ are affected by Tape Speed. See
for de-
tails.
Tape Type
Tape Type selects the active tape stock formulation. Seven
Tape Types are modeled in the UAD Ampex ATR-102. To se-
lect the Tape Type, click the TAPE button to cycle through the
available types, or click directly on the Tape Type value label.
The active Tape Type is highlighted in yellow.
Note:
The available Tape Types and defaults are dependent
on the current Tape Speed and Head values. The available
Tape Types, and the associated Tape Speed and Head values,
are shown in